MAC TOOLS ?TIGW150/230 V Manuel du propriétaire télécharger pdf (Page 14)

CobraTig

150 Owner's Manual - Page 7

• Press F4 or F9 and scroll to Curr. L. (A), low weld current in amps.

• Press F5 or F10 and enter Low current value from 0.2~150 amps.

• Press F4 or F9 and scroll to Pulse H. (S), high weld current pulse

time.

• Press F5 or F10 and enter High weld current pulse time from

0.00~0.99 seconds.

• Press F4 or F9 and scroll to Pulse L. (S), low weld current pulse

time.

• Press F5 or F10 and enter Low weld current pulse time from

0.00~0.99 seconds.

• Press F4 or F9 and scroll to Pre-Gas (S), pre-purge gas time.

• Press F5 or F10 and enter pre-purge gas time from 0.0~9.9 seconds.

• Press F4 or F9 and scroll to Post-Gas (S), post-purge gas time.

• Press F5 or F10 and enter post-purge gas time from 0.0~9.9

seconds.

• Press F4 or F9 and scroll to Strike (A), arc strike weld current.

• Press F5 or F10 and enter arc strike weld current from 0.1~25.0

amps.

• Press Foot Control to maximum and hold for duration of weld

• Press F6 Print Weld wave form graphics from integral printer

WELD MANUAL SCREEN DISPLAY

• F1, Start/Stop, used for manual Start/Stop operations without a foot

control.

• F2, Main Menu, returns to the Main Menu display.

• F3, Weld Orbital, returns to the Weld Orbital display.

• F4, Scroll UP, scrolls the highlighted eld from one demand

parameter to the next demand parameter.

• F5, Adjust Up, increases the numerical value of the demand

parameter selected. As this button is pressed for each parameter a

vertical bar graph displays the increasing value, both numerically and

graphically from the bar graph. For most parameters, a maximum

value is obtained once the vertical bar graph has reached the top of

the scale. Also, there is a change in the sound once the top of the

scale has been reached. The sound changes from a single beep to a

triple beep.

• F6, Print Weld, Data-Monitoring of manual weld produces a graphical

real time wave form of welding amps and arc volts.

• F7, Pedal On, selects the variable remote foot control for operation.

• F7, Pedal Off, selects the On/Off switch control and permits additional

programming of weld current Upslope time in seconds and Final

Slope weld current time in seconds.

• F8, Blank, no function control.

• F9, Scroll Down, scrolls the highlighted eld from one demand

parameter to the next demand parameter.

• F10, Adjust Down, decreases the numerical value of the demand

parameter selected. As this button is pressed for each parameter a

vertical bar graph displays the decreasing value, both numerically

and graphically from the bar graph. For most parameters, a minimum

value is obtained once the vertical bar graph has reached the bottom

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 28 29

Commentaires sur ces manuels

Pas de commentaire

MAC TOOLS ?TIGW150/230 V Manuel du propriétaire Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Système de soudage MAC TOOLS ?TIGW150/230 V