MAC TOOLS MW250 Manuel d'installation télécharger pdf (Page 38)

IP DECT Installation Page 38

15-601085 Issue 04f (11 June 2009)IP Office

3.4 Create an IP DECT Line

It is not possible to create more than one IP DECT Line.

Warning

· Adding a line requires the IP Office to be rebooted. That will end any current calls and services on the IP Office.

Information Required

· ¨ IP Office Login

Service user name and password with Administrator or Manager security group rights for the IP Office. Those

rights are required in order to create new extensions.

· ¨ ADMM Details

The IP address and MAC address of the base station acting as the ADMM.

· ¨ Base Station Details

The MAC addresses of the IP DECT base stations.

Tool Required

· ¨ IP Office Manager

PC with IP Office Manager.

Process

1.Start IP Office Manager and click to receive the configuration from the IP Office system.

2.In the left hand pane select Line.

3.Right-click on Line. Select New and then IP DECT Line.

4.The IP DECT Line option is greyed out if the configuration already contains an IP DECT line.

5.An existing IP DECT line is shown with a icon and the Line Type of IP DECT.

6.The Line tab is for information only. All the fields are greyed out and cannot be altered. The information shown on

this tab is described below.

· Line Number

Auto-populated on IP DECT line creation, starting at 240.

· Number Of Channels, Outgoing Channels and Voice Channels

Will change to indicate the number of IP DECT extensions associated with the IP DECT Line.

· Incoming and Outgoing Group ID

Auto-populated on IP DECT line creation, starting at 240. This value should NOT be used for outgoing call

routing as trunks calls to an IP DECT line will not be successful.

· Extensions

Shows the DECT extensions created within the IP Office configuration.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 109 110

Pas de commentaire

MAC TOOLS MW250 Manuel d'installation Page 38